Fixing the headstone

One-of the most critical areas of adding the headstone is the fixing within the ground. There has been much publicity concerning the dangers of falling or unsecured headstones and new health and safety rules have been put in place, several harmful headstones being laid all the way down to prevent accidents.

It is the responsibility of the builder to assess the surface conditions and determine which is the most suitable basis and repairing solution to be used. There are certain proposed solving practices which are detailed by NAMMs rule of practice, which have been tried by an unbiased structural engineer. Particular attention ought to be paid for the hole size and level stops to ensure the fixing is not affected. The most common fixing kinds which is being used by masons and suggested by NAMM will be the point fixing.

There are numerous repairing methods depending on the surface conditions, headstone size etc. The strategy that will be becoming one of the most widely used is the ground anchor and is strongly suggested by NAMM. That is the place where a ground anchor/steel bar runs from the base of the headstone deep in to ground. With this technique if a joint fails the headstone won’t fall down instantly if required is employed rather than falling on its own it’ll need repairing but will only fall over. You can even bolt the headstone again a reliable method using resin and metal dowels.

visit

It is usual for the headstone to be re-leveled and some headstones are put on a concrete base and your mason must return and do 2 visits free of charge for re-leveling. relevant webpage

Cemeteries will now do frequent checks on all the headstones in the cemetery and if your headstone needs correcting or replacing it will be down to the owner of the plot to simply take responsibility.

As long as the proper method is followed then your headstone should be securely fixed and not prove to be a risk.



Leave a Reply

Please copy the string uCNwdu to the field below: